Artigos
URI permanente para esta coleçãohttps://locus.ufv.br/handle/123456789/11800
Navegar
5 resultados
Resultados da Pesquisa
Item Separation of Cd and Ni from Ni–Cd batteries by an environmentally safe methodology employing aqueous two-phase systems(Journal of Power Sources, 2009-09-05) Lacerda, Vânia Gonçalves; Mageste, Aparecida Barbosa; Santos, Igor José Boggione; Silva, Luis Henrique Mendes da; Silva, Maria do Carmo Hespanhol daThe separation of Cd and Ni from Ni–Cd batteries using an aqueous two-phase system (ATPS) composed of copolymer L35, Li2SO4 and water is investigated. The extraction behavior of these metals from the bottom phase (BP) to the upper phase (UP) of the ATPS is affected by the amount of added extractant (potassium iodide), tie-line length (TLL), mass ratio between the phases of the ATPS, leaching and dilution factor of the battery samples. Maximum extraction of Cd (99.2 ± 3.1)% and Ni (10.6 ± 0.4)% is obtained when the batteries are leached with HCl, under the following conditions: 62.53% (w/w) TLL, concentration of KI equal to 50.00 mmol kg−1, mass ratio of the phases equal to 0.5 and a dilution factor of battery samples of 35. This novel methodology is efficient to separate the metals in question, with the advantage of being environmentally safe, since water is the main constituent of the ATPS, which is prepared with recyclable and biodegradable compounds.Item A green and sensitive method to determine phenols in water and wastewater samples using an aqueous two-phase system(Talanta, 2009-09-04) Rodrigues, Guilherme Dias; Lemos, Leandro Rodrigues de; Silva, Luis Henrique Mendes da; Silva, Maria do Carmo Hespanhol da; Minim, Luis Antonio; Coimbra, Jane Sélia dos ReisA greener and more sensitive spectrophotometric procedure has been developed for the determination of phenol and o-cresol that exploits an aqueous two-phase system (ATPS) using a liquid–liquid extraction technique. An ATPS is formed mostly by water and does not require organic solvent. Other ATPS components used in this study were the polymer, polyethylene oxide, and some salts (i.e., Li2SO4, Na2SO4 or K2HPO4 + KOH). The method is based on the reaction between phenol, sodium nitroprusside (NPS) and hydroxylamine hydrochloride (HL) in an alkaline medium (pH 12.0), producing the complex anion [Fe2(CN)10]^10− that spontaneously concentrates in the top phase of the system. The linear range was 1.50–500 μg kg^−1 (R ≥ 0.9997; n = 8) with coefficients of variation equal to 0.38% for phenol and 0.30% for o-cresol (n = 5). The method yielded limits of detection (LODs) of 1.27 and 1.88 μg kg^−1 and limits of quantification (LOQs) of 4.22 and 6.28 μg kg^−1 for phenol and o-cresol, respectively. Recoveries between 95.7% and 107% were obtained for the determination of phenol in natural water and wastewater samples. In addition, excellent agreement was observed between this new ATPS method and the standard 4-aminoantipyrine (4-AAP) method.Item Aqueous two-phase systems: An efficient, environmentally safe and economically viable method for purification of natural dye carmine(Tecnologia de Alimentos, 2009-11-09) Mageste, Aparecida Barbosa; Lemos, Leandro Rodrigues de; Ferreira, Guilherme Max Dias; Silva, Maria do Carmo Hespanhol da; Silva, Luis Henrique Mendes da; Bonomo, Renata Cristina Ferreira; Minim, Luis AntonioPartition of the natural dye carmine has been studied in aqueous two-phase systems prepared by mixing aqueous solutions of polymer or copolymer with aqueous salt solutions (Na2SO4 and Li2SO4). The carmine dye partition coefficient was investigated as a function of system pH, polymer molar mass, hydrophobicity, system tie-line length and nature of the electrolyte. It has been observed that the carmine partition coefficient is highly dependent on the electrolyte nature and pH of the system, reaching values as high as 300, indicating the high potential of the two-phase extraction with ATPS in the purification of carmine dye. The partition relative order was Li2SO4 ≫ Na2SO4. Carmine molecules were concentrated in the polymer-rich phase, indicating an enthalpic specific interaction between carmine and the pseudopolycation, which is formed by cation adsorption along the macromolecule chain. When the enthalpic carmine–pseudopolycation interaction decreases, entropic forces dominate the natural dye-transfer process, and the carmine partitioning coefficient decreases. The optimization of the extraction process was obtained by a central composite face-centered (CCF) design. The CCF design was used to evaluate the influence of Li2SO4 and PEO 1500 concentration and of the pH on the partition coefficient of carmine. The conditions that maximize the partition of carmine into the top phase were determined to be high concentrations of PEO and Li2SO4 and low pH values within the ranges studied.Item Sistemas aquosos bifásicos: fundamentos e aplicações para partição/purificação de proteínas(Química Nova, 2006-06-14) Silva, Luis Henrique Mendes da; Loh, WatsonBy the year 2005 the world biochemical market will reach an estimated $ 100 billion and separation processes are a vital link between lab discoveries and the fulfillment of this commercialization potential. The practical application of aqueous two-phase systems (ATPS) to extraction processes has been exploited for several years for the recovery of biological products. Unfortunately, this has not resulted in an extensive presence of the technique in commercial processes. In this paper a critical overview of the fundamental thermodynamic properties related to formation of aqueous two-phase systems and their application to extraction and purification of bioparticules is presented.Item Sistema aquoso bifásico: uma alternativa eficiente para extração de íons(Química Nova, 2006-07-06) Silva, Maria do Carmo Hespanhol da; Silva, Luis Henrique Mendes da; Paggioli, Fernanda Jürgensen; Coimbra, Jane Sélia Reis; Minim, Luis AntonioSolvent extraction has been successfully applied to metal ion preconcentration and often meant the use of toxic organic diluents. However, regulatory pressure is increasingly focusing on the use and disposal of organic solvents, and thus the development of nonhazardous alternatives is important. In this review, we examine the application of aqueous biphasic systems (ABS) to extraction of ions, analyzing their potential and limitations and suggest that ABSs could be an efficient substitute for oil/water biphasic systems. ABSs are formed by mixing certain inorganic salts and water-soluble polymers, or by mixing two water-soluble polymers.